Not signed in (Sign In)

Vanilla 1.1.5a is a product of Lussumo. More Information: Documentation, Community Support.

    • CommentAuthorsbdtasos
    • CommentTimeSep 16th 2010
     
    hello my name is tasos and i am from Greece i am build a v8 engine.i want to ask you about the timing puleys
    the plans that i have have the engine timing with gears and i want to fit puleys.
    can you help me and tell me about the pitch of the belt .what pitch is the best to choose 2,03mm 2,07mm 5,08mm

    thanks tasos
    • CommentAuthordavid
    • CommentTimeSep 17th 2010
     
    Tasos
    What is the bore of the cylinders and how many RPM do you expect?
    How wide will the belts be? I would suspect the 5.08mm(.2 inch) pitch would look about right.
    Make sure the temperature of the belt is good for engine temperatures.
    David
    • CommentAuthorsbdtasos
    • CommentTimeSep 17th 2010
     
    David
    the bore of the cylinder is 24mm about RPM i think up to 6000
    the wide of the belt is 6mm i find it in www.sdp-si.com
    the code is A 6A16M010DF6003 for the crank pulley
    A6A16M020DF6004 for the camshaft
    and A6Z16M249060 the belt


    thanks tasos

    if you can to check this it will help me
    • CommentAuthordavid
    • CommentTimeSep 18th 2010
     
    Tasos
    parts look good to me.
    David
  1.  
    Tasos:
    I'm rebuilding an 8 cylinder Schillings and it runs quite well using 1/4 inch belts.
    uses two of them, one for each bank of 4 cylinders.
    Belts are XL type and pulles are:
    Crankshaft 0.500 inches.
    Camshafts 1.00 inches.
    Engines are supposed to run over 9000 rpms, have not checked how fast it turns, since have not added the cooling lines yet.

    Your suggested pulleys and belt should work OK..

    Jaime
    • CommentAuthorsbdtasos
    • CommentTimeSep 19th 2010 edited
     
    thanks for the help

    if i have any other problem now i know were to find the solution

    tasos