Denis Moindrault, TAVERNY France didou-bike@wanadoo.fr
This is my submission for the motor gallery.
2 stroke nitro fuel motor
bore 26mm 1.02"
stroke 24mm 0.94"
12cc 0.75inch cubic
ignition by glow plug
Particularity :
-Rotary inlet valve, you can modify intake period
-openenable crankshaft for taking off the connecting road
-Crankcase and rotary valve are made in zinc metal alloy casting (I don't made my furnace in 1989 for aluminum casting)
Sorry if my English I not wonderful ! Denis
8/2/2009 Update
This is my new submission for the 0.75 homemade motor (always the same motor) :
I am made a hand puller :
Also I am made a centrifugal clutch whith teflon parts :
I am made a homemade 1/7 Cox for run my homemade motors (all is homemade except : boby, weels, shok absorber, mufler)
And now i am working on a homemade carburetor, it will be finish in few days
Thanks Denis
Copyright 2007, Florida Association of Model Engineers and engine builder as noted above, All rights reserved.