Return To Multi Cylinder Gallery    

Vaughn Hatch                     Siloam Springs, AR                 vhatch312@cox.net

Howell V2,  1.00 bore X 1.25 stroke      12/12/2011

 

I have attached a few photos of the Howell V2 that I am building.  Most of the major components with the exception of the valve gear case are complete.  I previously built two of Dale Detrich's engines.  The Howell has been a challenge for me but it is a good learning experience as well.  The engine is a 90 degree V twin with a 1" bore and a 1 1/4" stroke.  I hope to have it completed by Spring.  This engine has made me a firm believer in the value of good jigs and fixtures.

 

9/12/2012

Here is a photo of the Howell V Twin that I am currently working on. It is a 1" bore by 1 1/4" stroke 90 degree V engine designed by the late Jerry Howell.  I wanted to try something challenging for my third engine and this engine is a good challenge for my limited skills as a machinist. If anyone has built this engine I would like to correspond with them since we no longer have Jerry to give us advice.

 


 

Copyright 2011,  Florida Association of Model Engineers and engine builder as noted above, All rights reserved.