Dale Detrich,     Attica, OH   djdtrh@cros.net       11/13/2006

My 50 year old Sears tool box that retired with me..........

My work space , tool box and tools.

It may look aike confusion, but I know where "most" of the stuff is located.......

I have installed  a 3 axis DRO to the Smithy.....

Wall charts and DRO............

Smithy is fitted with a 2 HP vari-speed  DC drive motor....

My 1946 Logan 7" shaper.......I use it to level large blocks of material........You can set it and let it run itself.......

My cut off saw.....Brass is being cut for my "new" brass vari-compression engine

Shelf for supplies....

Bench grinder and brass supply.....

Some of my metal supply....

Over view of work area

lathe suplies

More lathe tooling

Chinese 7" X 12" lathe....after almost  rebuilding from the ground up, it is a good little machine....

Metal supply

7" lathe and small torch set.......

More engines

A pool table  used as a table to hold my engines....

More engines

more enginesMore stuff

In addition to engines building model guns is another one of my interests.

rgg scale gatling gun
 

1/3 scale rifle to set along the gatling guns fir scale.........The  rifle in real life is 51" long..............The rifle is .177 cal., and yes it has been fired.........Also both of the gatling guns have been fired..

RGG      Gun..........

1874 Colt

both guns

RGG

This is my 1/3 scale 1874 Colt gatling gun.....22 cal. shorts

This is my RGG  gatling gun........1/3/scale.........22cal. long...........

scale Colt gatling gun

1874 Colt gatling gun barrel

Copyright 2006,  Florida Association of Model Engineers and engine builder as noted above, All rights reserved.